Substituting the glue on an ME 35

Substituting the glue on an ME 35

Substituting the glue on an ME 35

-          DO NOT clean the glue tank with metal tools, since they will damage it. Use a wooden scraper.

Over time the glue deteriorates and loses it adhesive properties; proceed as follows to completely empty the glue tank and change the glue.

1.      Bring the glue to operating temperature and insert a piece of wood in the tank, immersed right through the glue with one end projecting approximately 10-15 cm from the tank.

2.      Turn off the machine and allow the glue to completely cool.

3.      Switch the machine on again and reheat the glue until it can be extracted with the piece of wood. (Recommended extraction temperature: about 90 to 110 degrees.)

4.      The remaining glue on the walls of the tank can easily be removed when it is tepid. (Recommended temperature: about 40 degrees.)


    • Related Articles

    • New Edgebander Plan

      Paying a little attention to proper setup and regular maintenance will go along way to keeping your edgebander productive. Edgebanders are the central machine in today’s panel-driven cabinet shop, but they are a complex machine and have a reputation ...

    • The Benefits of Pre-Mill on an Edgebander

      Introduction An edgebander is an essential piece of equipment in woodworking, used to apply edgebanding to the edges of various materials such as plywood, particleboard, and MDF. One of the key features of a modern edgebander is the pre-mill, a ...

    • Electronic control alarms on an ME 35

      Electronic control alarms on an ME 35